●The 5500 Canmaker is a new concept in 2-piece canmaking,based on the proven 5000 Series Bodymaker integrated with a new trimming unit.

●Cans are fed from the bodymaker into the vacuum infeed turret, and loaded onto self-centring tooling.

●Multiple ejector segments conform to the untrimmed edge, and the can is held stationary while the penetrating disc moves eccentrically against the outer knife ring, trimming the can in one revolution.

●The 3400 Die Necker is a multi-stage die necking machine, capable of producing cans at speeds of up to 3400 per minute.

The operator friendly, cost effective and easily maintained tool set includes the following key features:

●Hard anodised aluminium stripper plate with hardened steel wear strips
●Single or twin piston
● One piece outer guide pin assemblies
● Inner punch plate alignment facility
● Hydraulic lift for installation of inner punch
● Phased draw to reduce loads
● Hardened blank and draw die retainers concentric to within 0.0004"
● Swing out scrap blade holder
● Cup identification marking system
● Complete air discharge system
● Wheel assembly for easy installation/removal
● Field service engineers and technical expertise.

●30 to 1000* Gallon Bulk System for water or solvent based compound. * larger systems available

●All water-based systems are stainless steel.

●Compound Conditioning Systems. available for solvent base and plastisol.